Ski-Doo 2013 Manual
Ski-Doo · 2013 · manual · 743 pages
Technical data
Numbers below were extracted automatically from the document. Verify them against the original manual before you order parts or apply torque.
Tightening torque
Values extracted from the document text. Check against the original before service work.
| Item | Value | Also | PDF page |
|---|---|---|---|
| Spark plug | 28 N·m | 21 ft·lb | p. 29 |
| Drive pulley screw | 120 N·m | 89 ft·lb | p. 30 |
| Lock nut | 36 N·m | 27 ft·lb | p. 31 |
| Brake caliper bleeder | 9 N·m | 80 in·lb | p. 35 |
| Brake lever pivot nut | 6 N·m | 53 in·lb | p. 35 |
| Engine stopper screws | 10 N·m | 89 in·lb | p. 48 |
| EGTS Sensor | 45 N·m | p. 66 | |
| Tuned pipe temperature sensor | 45 N·m | 33 ft·lb | p. 70 |
| Oil tank SIDE screws | 8 N·m | 71 in·lb | p. 90 |
| Oil tank FRONT screw | 1 N·m | 9 in·lb | p. 90 |
| Stud ends of housing | 3 N·m | 27 in·lb | p. 122 |
| Cylinder Head Warpage | 24 N·m | 18 ft·lb | p. 142 |
| Cylinder screws | 25 N·m | 18 ft·lb | p. 143 |
| Cylinder screws | 50 N·m | 37 ft·lb | p. 143 |
| Water pump cover screws | 11 N·m | 97 in·lb | p. 166 |
| Bearing carrier screws | 6 N·m | 53 in·lb | p. 170 |
| Crankcase M6 screws | 11 N·m | 97 in·lb | p. 172 |
| Base plate M6 screws | 11 N·m | 97 in·lb | p. 173 |
| Base plate M8 First | 14 N·m | 124 in·lb | p. 173 |
| Screws Final | 29 N·m | 21 ft·lb | p. 173 |
| Oil seal cover screws | 11 N·m | 97 in·lb | p. 173 |
| Fuel pump spanner nut | 40 N·m | 30 ft·lb | p. 228 |
| Fuel hose retainer screw | 5 N·m | p. 253 | |
| Throttle body clamps | 1.4 ± 0.23 N·m | 12 in·lb | p. 269 |
| TPS retaining screws | 2 ± 0.45 N·m | 18 in·lb | p. 273 |
| ECM Engine mount screw | 25 N·m | 18 ft·lb | p. 291 |
| Capacitor screws | 2 N·m | 18 in·lb | p. 316 |
| Calibration screw | 10 N·m | 89 in·lb | p. 384 |
| Ramp screws | 12 N·m | p. 384 | |
| Locking nuts | 10 N·m | 89 in·lb | p. 388 |
| Pivot screws | 21 ± 1 N·m | p. 397 | |
| Cam screws | 32 N·m | 24 ft·lb | p. 397 |
| Bearing flange nut | 16 N·m | 142 in·lb | p. 398 |
| Brake pad pin | 10 N·m | 89 in·lb | p. 404 |
| Brake caliper screws | 25 N·m | p. 407 | |
| Washers | 35 N·m | 26 ft·lb | p. 407 |
| Pivot nut of brake lever | 6 N·m | p. 409 | |
| Washers | 27 N·m | 20 ft·lb | p. 409 |
| Upper sprocket screw | 48 N·m | p. 419 | |
| Suspension | 85 ± 10 N·m | p. 443 | |
| Front arm bolts | 47.5 ± 5.42 N·m | 35 ft·lb | p. 449 |
| Front arm bolt Rear arm connecting | 61 ± 9 N·m | p. 449 | |
| Chaincase rod screws | 61 ± 9.49 N·m | 45 ft·lb | p. 449 |
| Support screws | 5 ± 1.02 N·m | 44 in·lb | p. 450 |
| Clamp screws | 2.5 ± 0.45 N·m | 22 in·lb | p. 450 |
| Clamp screws | 0.4 ± 0.1 N·m | p. 450 | |
| Knob screw | 0.5 ± 0.11 N·m | 4 in·lb | p. 450 |
| Knob screw | 0.4 ± 0.1 N·m | p. 450 | |
| Knob screw | 1.5 ± 0.5 N·m | p. 451 | |
| Knob screw | 2.5 ± 0.45 N·m | 22 in·lb | p. 451 |
| Banjo bolt | 24.4 ± 4.07 N·m | 18 ft·lb | p. 455 |
| Shock absorber retaining | 24.5 ± 3.5 N·m | p. 458 | |
| Retaining screw | 24.4 ± 4.07 N·m | 18 ft·lb | p. 466 |
| Suspension | 3 N·m | p. 470 | |
| Suspension | 3.1 N·m | 27 in·lb | p. 470 |
| Suspension | 25 N·m | p. 470 | |
| Front arm nuts | 48 N·m | 35 ft·lb | p. 476 |
| Rear arm screws | 48 N·m | 35 ft·lb | p. 476 |
| Rear shock absorber | 25 N·m | 18 ft·lb | p. 484 |
| Throttle rods upper nut | 25 N·m | 18 ft·lb | p. 484 |
| Pivot arm lower nut | 25 N·m | 18 ft·lb | p. 485 |
| Ski runner nuts | 8 N·m | 71 in·lb | p. 491 |
| Handlebar clamps screws | 25 N·m | p. 496 | |
| Handlebar extension retaining screws | 25 N·m | 18 ft·lb | p. 497 |
| Upper steering column | 18 N·m | 159 in·lb | p. 500 |
| Lower steering column | 10 N·m | 89 in·lb | p. 500 |
| Gauge support screws | 2.3 N·m | 20 in·lb | p. 505 |
| Hood screws | 1.7 N·m | 15 in·lb | p. 509 |
| Mesh filter housing | 1.7 N·m | 15 in·lb | p. 510 |
| Headlight housing | 1.9 N·m | 17 in·lb | p. 510 |
| Console screws | 1.9 N·m | 17 in·lb | p. 511 |
| Bottom pan cover | 1.9 N·m | 17 in·lb | p. 512 |
| Front bumper screws | 10 N·m | 89 in·lb | p. 513 |
| Rear bumper screws | 16 N·m | 142 in·lb | p. 516 |
| Side bottom pan screws | 1.9 N·m | 17 in·lb | p. 516 |
| Rear bolts | 18 N·m | 159 in·lb | p. 524 |
| Side bolts | 14 N·m | 124 in·lb | p. 524 |
| Lower suspension | 34 N·m | 25 ft·lb | p. 528 |
| Inner nut | 14 N·m | 124 in·lb | p. 532 |
| Drive belt guard bracket | 3.3 N·m | 29 in·lb | p. 532 |
Capacities
Values extracted from the document text. Check against the original before service work.
| Item | Value | Also | PDF page |
|---|---|---|---|
| Fuel tank | 40 L | p. 534 |
Spark plugs
Values extracted from the document text. Check against the original before service work.
| Item | Value | Also | PDF page |
|---|---|---|---|
| Spark plug | 1 mm | p. 135 | |
| J1A-4 | — | p. 205 | |
| J1B-26 | — | p. 213 | |
| J1A | — | p. 297 | |
| J1B | — | p. 304 | |
| BR8EIX | — | p. 732 | |
| BR9-ECS | — | p. 732 |
Service intervals
Values extracted from the document text. Check against the original before service work.
| Item | Value | Also | PDF page |
|---|---|---|---|
| Coolant change | 5 years | p. 20 |
Get the document
The full file is delivered by the bot. Free owner guides for Ski-Doo are also available from the manufacturer.
Open in Telegram — the bot finds this document by its catalog id and sends the file.
Open in bot- Official free Ski-Doo owner's manualsParts catalogueAll manuals